krm logo

KRM HO 016

KRM HO 016
Information Page

Brass NSWGR Steam Locomotive Numbers

HO Etched Brass NSWGR Steam Locomotive Numbers

Price $9.25 (Aus$)

If ordering alone - postage on this item is $2.50, if with other products $5.00


Introduction
The kit which is available from the products page is a photo etched kit as discribed & indicated in the above photo.
As with all Photo Etched parts, be very careful when handling them, and always read through the instructions a few times before working with any new kit.

This etched brass HO NSWGR Steam Locomotive Numbers, that are supplied, will cover more than one locomotive and have enough numbers to be used on any NSWGR Steam Locomotive
The following numbers are supplied in the 0.3mm etch:

  • 6 x "0"
  • 6 x "1"
  • 6 x "2"
  • 6 x "3"
  • 6 x "4"
  • 8 x "5"
  • 6 x "6"
  • 4 x "7"
  • 4 x "8"
  • 4 x "9"


Step 1 - Tools & Equipment
 Tools & Equipment

If there is one thing that I would like to impress upon you, it is the benefit of using quality tools to do your work, The end result of any job is plainly due to the use of good quality tools. And there is also a saving by using good tools, because they last longer, and therefore you do not need to replace them as often.

  1. Stainless Steel Scissors
  2. Tweezers or other small no maring clamping device
  3. (Metric) Number Drills & Pin Vice
  4. Small Files
  5. Soldering Iron
  6. Hold & Fold Tool
  7. Solder & Flux or Solder Paint
  8. Snap-off Cutting Blade
  9. Fine Wet & Dry Paper
  10. 0.3mm brass wire (0.012")
  11. Burnishing Brush (Be very Careful)
  12. Selleys Acrylic Quickgrip
  13. Cutting Board
Lets get ready to Moddddddeeeeeelllllll

Order Form      Products Page

Happy Modelling

Keiran Ryan



This site was designed & built by Keiran Ryan Models